If you are looking for an inexpensive way of doing a quick re-roofing Hobart, Tasmania, Australia, the best method is to perform the re-roofing on your own. The first step to re-roofing is to gather the following materials: a metal screed about six inches wide with a length of one inch; roofing sheets of plywood attached at both the bottom and top with a reef screws holding them together at the headstock; a spade, and a hammer. Make sure that all of the items are clean and dry before you begin. When you have gathered these items and they are all dry, begin by removing the existing roof covers on the wall that has flashed between them and the wall. Next, remove the rafters and ceiling of the attic space.

Reroofing Hobart

Once the old roof has been removed completely, the next step in the process is to work on the screed. Use a hacksaw to cut along the edges of the screed to aid in the separation of the wood into strips that can be used to re-attach the roofing sheets. It is important to keep the metal strip separate from the wooden trim. Once the strips of wood have been removed, and the metal screed is free of any obstructions, the pieces can be glued together with a waterproof glue.

Once the roofing sheets have been installed on the rafters and attic ceiling, use a flat-head screwdriver to screw them onto the metal screw head. Do not forget to screw them onto the roofing plates down below as well. This will ensure that the roof panels stay in place and that no moisture will get into the attic. Be sure to check that everything is square before beginning the actual re-roofing. After the re-roofing is completed, you may want to use the flat-head screwdriver to screw the roofing plates back onto the screw head.

The final step in the process is to attach the hobart leaf strip to the rafters. Do not forget to anchor the strip to the rafters before the glue is allowed to dry completely. You may also want to add an extra screw at the top of the rafters to use as a tension screw. Do not worry about using an electric drill as the screws that you use should be able to grip the surface of the metal roof plate. With the new roofing done, you will now be able to enjoy your newly-renewed roof!

If you are having trouble getting the old roof to re-attach to the new roof, there are a number of options for you. The first option that you may want to try out is the use of roofing tar. This can be applied to the underside of the old roof and left to dry overnight. The following morning, remove the tar, and re-apply it to the entire length of the roof.

You can also use some roof tar to strip off the old roof. Take note that this may take quite some time depending on the extent of damage. It is always best to test out the procedure on a small section of the roof before applying it to the entire length of the roof. When you have gotten rid of the old material, it is time to nail in the hobart strips. Just remember to anchor each strip to the rafters in order to ensure that the new roof does not come loose.